DIRECTIONS

A. LIMITATIONS

1. Not to be used for exterior applications.
2. Do not use over presswood, chipboard, particleboard, Masonite, Luan, gypsum floor patching compounds, metal, plastic or other dimensionally unstable substrates.
3. Do not use at temperatures below 10° C (50° F).
4. When using a heavy veneer, greater than 10 lbs. per sq/ft, it is recommended that you use DYNA® MVM Masonry Veneer Adhesive for installation.
5. Do not us in pools, tanks, jacuzzis or fountains. Use DYNABOND 400 mixed with DYNALASTIC 5000 for this type of installation.

B. SURFACE PREPARATION

1. Ensure that the substrates are structurally sound, solid, stable, well fastened, dry, clean and free of dirt, grease, oil, tar, wax, curing agent, etc., or other substances which may prevent or reduce the adhesion of this product.
2. Painted surfaces must be completely sanded, scrapped, or chipped to promote adhesion.
3. Surfaces should be cleaned with DYNA® cleaning solutions.

C. APPLICATION

DYNA® MVA Masonry Veneer Adhesive is ready to use out of the packaging. There is no mixing required.

1. Open the container and spread adhesive with the recommended notched trowel into the substrate.
2. Use a notched trowel with sufficient depth to achieve a covering of at least 85% of the brick’s back.
3. Do not spread more than can be covered with bricks within 30 to 45 minutes. If skinning occurs, scrape off and replace with fresh adhesive.
4. Place the brick firmly into position with a slight twisting motion to ensure a good bond.
5. Make all alignments and adjustments immediately (do not exceed 45 minutes).
(Make sure the veneer is clean and free of dust, oil, wax, etc.)

D. EXPANSION AND CONTROL JOINTS

- Provide expansion and control joints where specified.
- Do not cover any expansion joints with DYNA® MVA.
- Cut bricks on both sides along the edges of the expansion joints.
- Also insert the compressible bead and sealant to caulk the expansion and control joint.
- Follow ANSI AN 3.8, “Requirements for Expansion Joints”.